HP / Hewlett-Packard

Beschreibung und Lösung: 010091 error (Continuable) Error in Paper-axis Motor Encoder

Beschreibung und Lösung: 010092 error (Continuable) Mark Encoder position not detected on Drive Roller

Beschreibung und Lösung: Designjet 5000/5500 ffff ffff xxxxxxxx error General firmware error

Beschreibung und Lösung: ffff ffff 02b301b0 error This error usually appears at the beginning of Printhead Alignment due to a firmware bug. If requent, upgrade firmware to A.02.xx

Beschreibung und Lösung: ffff ffff 01dcxxxx error There is a problem with the I/O Card (happens during power up)

Beschreibung und Lösung: ffff ffff 030d0170 or 030d0171 error At power-up, the Printer thinks it is smaller than 42 inches

Beschreibung und Lösung: ffff ffff 031609xx error This error code only appears if the Main PCA was replaced without removing the media from the printer, because the firmware tries to find the last media information in the EEROM. Since the

Beschreibung und Lösung: ffff ffff 03450097 error If the Window is opened during the cutting operation, the Printer hangs and the Carriage suddenly stops. If you press any key on the front panel ffff ffff 03450097 may be displayed. Re-boot

Beschreibung und Lösung: ffff ffff 036000bd error This firmware error code is related to the detection of the Printhead cleaners by the line sensor. It always happens during initialisation, while checking the Printhead Cleaners. In most cases, it is a

Beschreibung und Lösung: ffff ffff 036e0136 error This is an internal general error code which can appear during the Printhead Alignment process. The chance of this error appearing is less than 0.5% and there is nothing wrong with the printer.

Beschreibung und Lösung: 01002D error (Non-Continuable) The main PCA cannot communicate with the Carriage

Beschreibung und Lösung: 010023 error (Non-Continuable) EEROM Test failure

Beschreibung und Lösung: 85:03 error Problem finding the drive roller zero

Beschreibung und Lösung: 86:03 error Scan-axis lenght test failure

Beschreibung und Lösung: 86:10 error Initialising scan-axis motor failure

Beschreibung und Lösung: 91:10 error Repeated printhead issue

Beschreibung und Lösung: 93:11 error Unable to pressurise the IDS

Beschreibung und Lösung: 98:02 error Switching to lower performance due to printhead quality

Beschreibung und Lösung: 74:01 error Error uploading firmware

Beschreibung und Lösung: 74:04 error Old vacuum fan detected – upgrade the firmware