Scanner

Beschreibung und Lösung: 0D0004 xxxxxxxx error (Non-Continuable) This is an internal general error code which can appear during the Printhead Alignment process. The chance of this error appearing is less than 0.5% and there is nothing wrong with the Printer.

Beschreibung und Lösung: 0B000X error Unable to detect Fan (X= 7-Vacuum, 8-Cooling, 9-Aerosol)

Beschreibung und Lösung: 0B0010 xxxxxxxx error This firmware error code is related to the detection of the printhead cleaners by the line sensor. It always happens during initialisation, while checking the printhead cleaners. In most cases, it is a problem

Beschreibung und Lösung: Designjet 5500 0B000F error (Continuable) Only applicable to Designjet 5500 series. Unable to detect the Heater. If this error appears, all settings related to the heater will disappear from the front panel.

Beschreibung und Lösung: 0C0032 error (Continuable) Drop detector not calibrated or the calibration settings have been lost

Beschreibung und Lösung: 0C0040 error Error in Printhead Drop Detection. This error code appears when the Printer detects that the same area of nozzles do not work in different Printheads. The possible causes are either fibres or a piece of

Beschreibung und Lösung: 0C00FF error Print Mask could not be generated. The mask generation algorithm could not generate the print mask. Possible causes are memory corruption, print mode definition incompatible with mask restrictions (if using an external RIP). This cause

Beschreibung und Lösung: 0D0000 error No media profiles available

Beschreibung und Lösung: 0D0000 033f019C No media profiles available

Beschreibung und Lösung: 040000 error 01E603D9 This is an error that is related to the parallel port. It happens normally in new printers and only once (it is unlikely to happen again). Even if the error appears again, there is

Beschreibung und Lösung: 050000 error (Continuable) Lens has problems reading the Mark Encoder on the Drive Roller

Beschreibung und Lösung: 050001 error (Continuable) Lens has problems reading the Mark Encoder on the Drive Roller

Beschreibung und Lösung: 06030C error Bad line sensor

Beschreibung und Lösung: 06040C error Line sensor not connected correctly

Beschreibung und Lösung: 0A0050 error (Non-Continuable) The printer had detected a leak in the Tubes System (should only appear in printers with the Ink Leak Detector installed)

Beschreibung und Lösung: 0A0060 error (Non-Continuable) The Printer has detected a leak in the Tubes System (should only appear in printers with the Ink Leak Detector installed)

Beschreibung und Lösung: 0A0070 error (Continuable) The Backup EEROM contents stored in the Hard Disk Drive are not consistent with the ones required by the firmware

Beschreibung und Lösung: 011000 error NIB Crash. Power printer off and on again using the power switch at the back of the printer

Beschreibung und Lösung: Designjet 5000/5500 ffff ffff xxxxxxxx error General firmware error

Beschreibung und Lösung: ffff ffff 02b301b0 error This error usually appears at the beginning of Printhead Alignment due to a firmware bug. If requent, upgrade firmware to A.02.xx